Recent content by captrichc

I'll do a water run then I guess on sunday

reset all of my process for my system havent brewed in 2 years. have a brew date for the 24th. pretty stoked about it.

is there a way to test the designed process setup without doing a full run through? so in essence to make sure everything will run/fire the way its suppose to?

I was able to upload and set everything. Thanks for the help..

didnt pull my processes.... even though it said done. do i have to power cycle?

is there no all stop anymore?

dam that also means i have to reset all of my processes as well right? im going to have to break out all of my old notes to figure out my hold temperatures etc as well..... right?

well that sucks....... i only saved my layout. that means im going to have to rewrite all of outputs.....? i guess that will be another night.

can you provide a link to do this please. thanks

hello everyone i just updated my bcs 462 to 4.0.1..... yes i know im late to the party. was out of brewing for about 2 years. how do i load my configuration back into the system that i savd right before i upgraded?

A couple of months later, any updates?

Hoppo did you have any boiling issues or temp probe issues with the system? I got mine hooked up and I am having an issue where I can't get about 209° and my probes are about 2 ° off low.

Sorry to dig up an old thread. I am in the process of redoing my garage and i wa Ted to put in a cold room to store my bulk hops, my 4 30g fermenters, and grain. The whole room will be independently insulated with a window AC unit installed through the cinder block wall controlled by a cool...

Great. Thanks. One last question. Will the coding work from the original postings.

Ok. So these still get wired with a 4.5 or a 4.7k resistor correct. Also does each sensor get the resistor? Or is 1 resistor for all of the runs since they all go to one spot..