Recent content by BigHefty

I guess I don't understand what console you are talking about. But, I'm not able to go back and see it now anyway as I ended up backing up and reflashing like you said. However, to help track this bug down, I'm willing to flash ispindel back on one of my units and go back to gravitymon to see if...

This is a snip of where it shows the error.

I keep seeing "iSpindel configuration file has been detected, do you want to copy formula and gyro calibration ?" after updating my firmware. I've pressed the migrate button many times and I get a failed error. It works fine, I just keep getting this message and want to clear it. How do I do that?

Upgraded and working fine.

Everything worked up until the successful device registration. I got "Format stored successfully. Home Assistant Device Registration Failed!" I then tried entering the config statements one at a time. It kept working until I got to the last one and it errored out. I deleted everything except...

Doesn't seem to be working for me. I flashed one of my units, deleted it from HA, did an MQTT test send and HA doesn't report receiving anything. I've rebooted both with no luck.

When I looked at the HA logs, it appears that iSpindel will register the device and then subscribe to it. The next message that comes in is just the data message. I hope I'm explaining this correctly, I don't know very much about MQTT.

I ended up making a few changes. I changed the "dev-cla" of battery to "voltage" and rssi to "signal_strength". I removed it and unit of measure from tilt. I also created a new one so I could see the current software version by adding...

Working like a champ!!!

Well then you'll have a new release out long before I'll actually use this for a batch! LOL

I've come up with a workaround for now. As long as I don't restart HA, everything works fine. I don't know how to configure/code so that HA doesn't forget the entities after a restart. So, I copy and paste the following lines into the MQTT part and save it. As you already know, it saves it but...

That's awesome!!!

Well right now I have Battery Voltage, Gravity, Signal Strength, Temperature, and Tilt. I think those are just the defaults that iSpindel passes along to HA.

I haven't tested it to see how it performs real world. I just liked the auto discovery. I tried looking at the code to see if it was something I could incorporate into GravMon but I'm just not that good with code. :ghostly:

Ok yep... that's how they show in mine too.