Recent content by Barron

Looks like I’ve got a problem with my temp probe

I do have one. What do I need to do to troubleshoot?

I've got a PT100.. Everything seems to be secure with no loose connections.

Hi everyone! I finally got my panel wired up and ready to go and ran into this problem right when I started to heat my mash water. Ran an autotun last night and everything worked great. I'm not really sure what's going on? <iframe width="560" height="315" src="" frameborder="0"...

I have a glass cooking surface and have mashed in a few time using my 11gal pot. I didn't really think to much about it until now.

I reached out to Auber and they sent me an Interlock troubleshooting guide. Everything was ok except for 1 & 6, they didnt show any voltege. Any sugestions on what might be goin on or what i should do next?

Unfortunately that was not the issue[emoji53]. I'm not sure what's going on with this panel? Everything seems to be wired right looking through the diagram.

Well I'm pretty sure I found my problem. A2 on the main power contactor is missing a screw. Ordered a new contactor and it will be here Thursday. Hopefully everything else will work properly after that.

One wire comes out of terminal 3 of the power switch to 9 on the timer. The other comes out of terminal 3 to the timer alarm.

That is correct. Here's a video of the panel powered on and this is what happens when i turn the element or pump switches on.

Everything seems to match up. Im begining to think its a grounding issue? the nuts that are on the grounding post dont fit well and all the grounds are not totally tight to the post. Could this be part of the problem?

Thanks! I'll give that a try when I get home.

It looks like it is correct?

Thanks Doug! I'll go take a look.

Here is the diagram for others to look at.