Recent content by adamant

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. A

    floating dip tube?

    Seeing that, and not wanting to pay $50/keg is what started me on this quest and led me to this thread.
  2. A

    Colonna Corker Mods for Bottling Belgians

    You can also adjust the handle and put a mark so that you know where to pull it to to get the right depth. That was my method.
  3. A

    Colonna Corker Mods for Bottling Belgians

    You can also adjust the handle and put a mark so that you know where to pull it to to get the right depth. That was my method.
  4. A

    floating dip tube?

    I know you haven't posted to HBT in a while, but I was wondering if you still use this method, or have made improvements, or given it up. I am considering giving it a shot. Has anyone else tried it? I was thinking about modifying the design slightly, by gluing some very small weights...
  5. A

    My Weldless Build Using Strut

    I built my strut stand using his measurements. I am not finished yet, but I think it would work out well.
  6. A

    My Weldless Build Using Strut

    My local electrical supplier charged $16 per foot, AND they cut them custom to my preference. I even had some wildly mismatched cuts on each section to minimize waste (I was able to buy one less 10ft section by distributing the various sizes across multiple pieces)
  7. A

    McMaster Keg O-Ring List

    Homebrewfinds.com did a post with links recently.
  8. A

    My Weldless Build Using Strut

    Picked up my strut today, and I'm about to order my fittings. FYI there is a coupon code for strutchannelfittings.com "SAVE" for 10% off. I was planning on going for a 2 tier system, but looking at the cost for the fittings and additional strut, I think it is wisest in the long run to just...
  9. A

    Single tier brewstand design and build (stores keggles inside)

    Someone had a similar build (with keggle storage). They painted it blue and had a removable PID control panel. Can someone help me find the link?
  10. A

    My Weldless Build Using Strut

    Menards has some urethane powder coated strut channel (green only). How well does that hold up to heat? http://www.menards.com/main/electrical/rough-electrical/strut-supports/strut-channel-12-gauge-green-10/p-1628627-c-12477.htm
  11. A

    understanding high pressure versus low pressure propane

    Thanks. I appreciate the insight. It would be cool if there were adjustable orifices, but swapping out a $7 part is pretty reasonable.
  12. A

    understanding high pressure versus low pressure propane

    hmm, how much performance reduction is there if you used LP with an NG orifice or NG with an LP orifice?
  13. A

    understanding high pressure versus low pressure propane

    Any idea how different the orifice sizes are on those valves that you linked?
  14. A

    understanding high pressure versus low pressure propane

    Is there any other difference between the 8200 and 8300 other than outlet size? Nevermind, I see this addressed above, now. Looking at 2NobleDog's rig on the first page of the thread, he has 2 2-stage regulators coming from his manifold. Is that necessary, or could 1 regulator coming off the...
  15. A

    understanding high pressure versus low pressure propane

    Awesome, thanks.
See more
Back
Top