Recent content by aceofspades1217

I knew I should just post here before I do anything ;) Thank you sooooo much. Although I am thinking of getting a 2 tap tower so I hook up some corny kegs (I sniped a 2 output regulator for only $45 on ebay).

I bought a scratch and dent beer tower for only $37 (to replace a broken one) from beverage factory but it is too big for my kegerator's screw holes and I can only screw one hole in. Should I just scrap this beer tower and buy a brand new one that will actually fit or can I be ghetto and...

So basically all the parts from my old tower. It is just too bad that I bought the wrong piece. Really wanted to have that kegerator running so I could pre-game for a concert tomorrow :P. If I use a pump tap won't it ruin the keg?

I ended up just returning the piece to sender because it wasn't for a tower. However, I found a tower for $35 (+$10 shipping) . That way I can just got a fresh new tower (the tower that came with it is grimy as hell). I should have made it clear it was a tower. It says "Mounting Gasket and...

I just got the assembly...I can't figure out how to take out the old one and replace it with the new one.

It is probably the tail piece end of the shank. Where can I buy one of those? I havent really seen those on beverage factory.com. I don't have a beer shop near myself. Will this work? http://www.micromatic.com/draft-keg-beer/taps-faucets-pid-4329A-3E.html?AffiliateID=25847

I got some silicone grease from loews (closest thing to keg lube) and it didn't help at all. Just made the shank even more likely to slip out. ever since i put silicone grease it got A LOT worse. Now it won't stay in at all and if I turn on the CO2 it flys out. I am really worried about my keg...

I tried using every O-ring and gasket I could find but they only make it leak more. http://s426.photobucket.com/albums/pp342/aceofspades1217/Kegerator/ Here is the pictures of the leak. It is leaking into the kegerator And here is all the parts I have, Well any of these help?

It is not the end that connects to the beer line, it is the end that goes into the faucet. Its leaking about a pint every two hours. Can I just put some rubber cement on it? I just feel like I am missing something, because the barb doesn't realy screw in.

Hello, I just bought a beer meister kegerator off of craigslist and when I got it the tubes were very dirty so I decided to replace them. However, now that I have replaced the tubing the metal tube that goes into the faucet is leaking and it does not have a very good seal at all. I am not...