vballdrummer
Well-Known Member
Ok, so I could not resist picking this up. It's a heat exchanger - the 1/2" inner tube has sanitary fittings on each end and the outer jacket has 1/2" FPT on each end. At first I thought indirect heat RIMS tube, but i don't think there'd be enough surface area to be effective running hot water through the outer jacket. Then I found some sort of resistance heaters (in photo) with the same curvature, each 450W @ 240V. I'm thinking of banding two of these on (three may not fit) and see how 900W handles sparge flow rates.
So, any ideas of how this might be put to good use?
So, any ideas of how this might be put to good use?