AtomicGecko
Member
Have been doing a lot of research through the beer forums...I really like this design. I have started building. Since my talent lies more in wood working rather than metal working I built the frame out of wood. I did find a few example of Wood Brutus 10s to follow. Yes I use propane and my current rig is wood. With air gap and some metal shielding there is no problem. The picture below chronicles the build to date. I'll post picture as I progress and funding allows.
Starting to put together the frame... squaring the corners
Top and bottom frame constructed
Attaching the vertical supports
Basic frame constructed
Fitting the wind screen/heat shield. Yes it is stainless sheet...some recently acquired scrap cut and fitted in a trough shape. The burners will go inside.
Added a top rail
Added casters
Applied stain
Applied 2 coats of polyurethane
1 1/2" angle iron will serve to support the keggles. It is cut to length and drilled for...1/2 x 4" bolts will attach to frame...cross members are coming that will go width wise across the angle iron support.
Starting to put together the frame... squaring the corners
Top and bottom frame constructed
Attaching the vertical supports
Basic frame constructed
Fitting the wind screen/heat shield. Yes it is stainless sheet...some recently acquired scrap cut and fitted in a trough shape. The burners will go inside.
Added a top rail
Added casters
Applied stain
Applied 2 coats of polyurethane
1 1/2" angle iron will serve to support the keggles. It is cut to length and drilled for...1/2 x 4" bolts will attach to frame...cross members are coming that will go width wise across the angle iron support.