johnthemate
Member
ok, I think I might have made a mistake cutting out the lids before doing a bit more research..( perhaps those 2 inch sanke holes could have been nice exits with tri clamps).. too late. but before anyother major leaps of faith, ill put together more of a design.. and would be grateful for any guidance.
Aims of system.
Small footprint
I have 3 x 5 gallon kegs... but if I can get away with 2 all the better
Aesthetically pleasing
I think I want to go Electric and RIMS
I think I can get away with one pump and water pressure
3 valves and a few quick disconnects
Thoughts I have had so far.
Would have been nice to use the CFC ( I have a convolutus) as a HX, but design wise it dosent seem to make sense - please correct me if I have missed something.
HLT inlet will be of a whirlpool design. MLT will have some sort of spray device so as not to upset the grain.
I need to research a hop back, and element ratings along with all the electrical stuff.
Thanks to anyone who can help.
Aims of system.
Small footprint
I have 3 x 5 gallon kegs... but if I can get away with 2 all the better
Aesthetically pleasing
I think I want to go Electric and RIMS
I think I can get away with one pump and water pressure
3 valves and a few quick disconnects
Thoughts I have had so far.
Would have been nice to use the CFC ( I have a convolutus) as a HX, but design wise it dosent seem to make sense - please correct me if I have missed something.
HLT inlet will be of a whirlpool design. MLT will have some sort of spray device so as not to upset the grain.
I need to research a hop back, and element ratings along with all the electrical stuff.
Thanks to anyone who can help.