Derick_Z
Well-Known Member
My old dorm fridge 2-keg kegerator died not long ago so I hit Craigslist looking for deals and came across a 14.8 cu ft chest freezer for $65 so I immediately jumped on it. It looks to be in great condition and the sellers were very friendly. The internal dimensions are 22 in by 33 in on the floor excluding the hump, and the compressor hump is 9 inches wide. I only have 2 kegs right now, but I should be able to fit 7 in there eventually I think.
I haven't really done any research on keezers in a while.. what's the current consensus on whether you should attach the collar to the lid or body? I noticed the lip on the body is sloped in slightly.. will that make a difference?
I was thinking of just using 2x4s for the collar, any issue there? Additionally i looked at the gasket briefly to see how to remove it if I wanted to put the collar on the lid, and can't figure out how to get it off. It looks like it's tucked under the plastic covering the lid, with some little pegs or something holding it in place.. any idea how to remove it easily so I can attach it to the collar?
Thanks!
I haven't really done any research on keezers in a while.. what's the current consensus on whether you should attach the collar to the lid or body? I noticed the lip on the body is sloped in slightly.. will that make a difference?
I was thinking of just using 2x4s for the collar, any issue there? Additionally i looked at the gasket briefly to see how to remove it if I wanted to put the collar on the lid, and can't figure out how to get it off. It looks like it's tucked under the plastic covering the lid, with some little pegs or something holding it in place.. any idea how to remove it easily so I can attach it to the collar?
Thanks!