New Controller Build Simple Question

[radllc]

Hi all,

New to electric brewing but not electricity.

I am using Doug's diagram below on my build.

The SW11's in this diagram are 120volt (not 240) correct? Just double checking - as the switches are taking in a neutral and hot on the lighted indicator but passing through two separated hots on the switch depending on switch position. I get that IND-1 indicator is 240 as it is taking in two simultaneous hots.

Thanks.

 

[doug293cz]

The specific switches called out in the design are all rated for up to 10A @ 240V, even though they are only switching 120V. The only switch that carries significant current is the pump switch, which should be less than 2A steady state, with a bit of a current surge on pump start up.

Brew on

 

[radllc]

Got it, thanks for your response!