So I am hoping to set up a controller for my eBrewery I am working on. I am looking to control the following:
1 240v heating element
2 temp probes
2 pumps
I am going to have a BK/HLT and going to heat the wort via counterflow chiller connected to the mash tun. I have never built a Raspberry Pi before so this is all new to me. I am really trying to get a handle on what components I will need. I believe I will get a
RASPBERRY PI 3 MODEL B+ kit from amazon with the power supply and 32 gb
Micro SD Card. I am going to look into the either an official Craftbrew Pi board or the
Terragady one. I don't really know the difference yet.
After that I am lost. I need to know what other components are needed to control and get feedback from the above items. I think I need one of these for the heating element and maybe the pumps?
Mager SSRs
https://www.amazon.com/gp/product/B076H12C3J/?tag=skimlinks_replacement-20
What do I need too interface with temp control and power supply for heating element and pumps etc? Do I still need some type of box to put all this in?
Any help or if you could point me to a good clear primer would be awesome. Thanks
1 240v heating element
2 temp probes
2 pumps
I am going to have a BK/HLT and going to heat the wort via counterflow chiller connected to the mash tun. I have never built a Raspberry Pi before so this is all new to me. I am really trying to get a handle on what components I will need. I believe I will get a
RASPBERRY PI 3 MODEL B+ kit from amazon with the power supply and 32 gb
Micro SD Card. I am going to look into the either an official Craftbrew Pi board or the
Terragady one. I don't really know the difference yet.
After that I am lost. I need to know what other components are needed to control and get feedback from the above items. I think I need one of these for the heating element and maybe the pumps?
Mager SSRs
https://www.amazon.com/gp/product/B076H12C3J/?tag=skimlinks_replacement-20
What do I need too interface with temp control and power supply for heating element and pumps etc? Do I still need some type of box to put all this in?
Any help or if you could point me to a good clear primer would be awesome. Thanks
Last edited by a moderator: