So brew day was two weeks ago, first time ever doing full grain and I did a BIAB method. Right before pitching (75 degrees) I was really stoked to see the refractometer show that my SG was 1.050, the target was 1.051.
Recipe is a"Blonde Rye" From AHS if it matters, yeast used was White Labs "Dry English Ale 007".
When the 1st week passed I did not measure, I could tell this batch did not have the rigorous fermentation that my high gravity ales usually do, I decided to just leave it alone and check next week. That was today.
I pulled the lid back to get a sample, refractometer today shows 1.027, recipe says it should have been at 1.014 by last week before moving to secondary. So obviously I've got some sleepy yeasties, and now I am wishing I had taken a reading last week, for all I know it was at 1.028 last Saturday.
Bottom line...what should I do?
I figure if I call Austin Home Brew they'll say to buy another yeast pack and add it in.
Should I agitate the entire bucket?
Should I just chill and let it go until it hits 1.014 or at least falls below 1.020?
Recipe is a"Blonde Rye" From AHS if it matters, yeast used was White Labs "Dry English Ale 007".
When the 1st week passed I did not measure, I could tell this batch did not have the rigorous fermentation that my high gravity ales usually do, I decided to just leave it alone and check next week. That was today.
I pulled the lid back to get a sample, refractometer today shows 1.027, recipe says it should have been at 1.014 by last week before moving to secondary. So obviously I've got some sleepy yeasties, and now I am wishing I had taken a reading last week, for all I know it was at 1.028 last Saturday.
Bottom line...what should I do?
I figure if I call Austin Home Brew they'll say to buy another yeast pack and add it in.
Should I agitate the entire bucket?
Should I just chill and let it go until it hits 1.014 or at least falls below 1.020?