I didnt prime my keezer

[reuliss]

I painted it without primer. Stupid. Is there any sort of acrylic sealer that I can put on top to prevent it from scratching?? Or need I strip it of the paint (a really nasty job) and then prime and repaint?

 

[r8odecay]

Did you use appliance paint?

 

[reuliss]

Did you use appliance paint?

I used a valspar paint that indicated use for metal surfaces.

 

[hank1105]

I lightly sanded mine then used enamel paint. Came out good but can scratch really easily. At this point I can just touch up the areas. I should have primed prior but o-well.

 

[NWAleDad]

Priming will not change the durability of the top coat. It will only help adhesion and create an even sheen if the substrate is uneven. If you are looking to add a protective coat on top use a water based clear finish.

 

[reuliss]

Priming will not change the durability of the top coat. It will only help adhesion and create an even sheen if the substrate is uneven. If you are looking to add a protective coat on top use a water based clear finish.

Really? Well that makes me feel better for my delinquency. Would such a clear finish improve the durability? Are there any brands you can recommend?

 

[nab911]

What he said. Primer is to make the bottom coat easier to adhere to or to help a light color cover up a darker color. You need a nice clear top coat to protect it. I am sure there are even some made specifically for appliances that will be thick and scratch resistant.

 

[Monster Mash]

Since freezers are already painted they should be sanded and cleaned before painting. I didn't use primer, I just sanded it down, cleaned it and painted it with chalkboard paint. So far I don't have any scratches even after writing with chalk several times.

 

[reuliss]

Thanks for all of the replies. You all have made me feel better. It's one thing having to go get some sealer and paint a layer on there (easy). It's quite another having to strip existing paint from a surface only to start all over again.

 

[DakotaPrerunner]

Stick with the same brand for a clear coat. Its best not to mix and match when it comes to paint.

 

[browder]

Epoxy spray paint no primer needed-same as appliance paint go to auto parts it'll be cheaper--I get mine at Auto Zone they've got better color selection think it's VTH--I use it on motorcycle frames pretty tough after it sets up for a week or so and you get a really nice finnish without runs

 

[NWAleDad]

Any brand of clear water based top coat will be fine. If you are unsure, just apply a little bit in a place no one will notice, wait for it to dry and come back and check it. The importance is water based. Oil based will yellow over age and solvent based will peel the paint.

Just an FYI that over time the below layer *might* start to crinkle. This is caused by the clear coat continually adhering over time and "grips" the bottom layer of paint and pulls it apart. If that does happen, sand, prime, paint. Viola!