How to clean the burs from insides of the copper pipes?

[TheDirtySpoon]

I cut the slits in the copper tubing but wondering how to clean the burs out of the tubing.

 

[keiths]

Use a small flat file file.

 

[polecreek]

most tubing cutters have a triagular blade on the back that fits in the copper so you can ream it.

 

[Cpt_Kirks]

Take a piece of sandpaper and fold it so the sand is on the outside. Stick it in the slot and go at it.

 

[bull8042]

I cut the slits in the copper tubing but wondering how to clean the burs out of the tubing.

I used a round chainsaw file from each end to knock the burrs out of mine. They are usually just barely hanging on, so it shouldn't take too much work anyway.

 

[TheDirtySpoon]

Thanks I will try the methods out and see if i can get them clean.

 

[nicksteck]

a step bit in a drill

 

[bull8042]

I think some people are missing what the OP is looking for. He is not looking to deburr the end of the pipe. He has cut slits across the pipe for use as a manifold if I am reading his post correctly.

 

[AnOldUR]

Get a piece of 3/8" diameter steel or aluminum rod long enough to go beyond half way into you tube. Use a hack saw to put a slit about an inch long in the end perpendicular to the diameter. Fold a short piece of emery cloth in half and put it in the slit so it sticks out each side a half inch. Put this in a pistol drill and use it to hone out the tube from both ends.





Did I explain that right? A picture would be better

 

[AiredAle]

My variant on AnOldUR's was to take a 3/8" wood dowel, cut a slit in the end and jam a 3/4 X 1 1/2" piece of green scrubby in the slit, mount the dowel in my cordless drill, mount the copper pipe section in my vice. Wrap the tag end of the scubby around the dowel tip, insert carefully in the pipe, and ream away. Worked great, like others say, the burrs aren't too hard to clear. Dowel was easier to find in my shop and easier to slot the end than a metal rod would have been. Green scrubby wasn't as aggressive on the rest of the inside of the tube as sandpaper might be.

 

[Yankeehillbrewer]

I used a round chainsaw file from each end to knock the burrs out of mine. They are usually just barely hanging on, so it shouldn't take too much work anyway.

That's exactly what I did, worked great. Any small round file will work well.