BlueSunshine
Well-Known Member
I bought this grain mill last week:
http://www.amazon.com/dp/B000PCDTNI/?tag=skimlinks_replacement-20
Do you think this is adequate to crush grain? I tested it out and it looked a bit too fine.
Then again, I used a rolling pin on my last batch and I thought it was too fine (lots of stuff left behind, but then again I'm not sure if this is normal or not). Any opinions?
http://www.amazon.com/dp/B000PCDTNI/?tag=skimlinks_replacement-20
Do you think this is adequate to crush grain? I tested it out and it looked a bit too fine.
Then again, I used a rolling pin on my last batch and I thought it was too fine (lots of stuff left behind, but then again I'm not sure if this is normal or not). Any opinions?
Last edited by a moderator: