I have an unused 30A 10' power cord for powering a 30A control panel. It plugs into a standard 4-slot North American dryer wall receptacle (240V/30A NEMA 14-30R with ground). http://www.theelectricbrewery.com/control-panel-power-cord. Cost $77 plus shipping new. $50
Also a new 6′ replacement cable, green wrap, for use with a temperature probe. http://www.theelectricbrewery.com/custom-temperature-probes Paid $35 new plus shipping. $25
2 SSR relays; one 30A double pole, double throw relay; Amp meter/50A shunt, heat shrink tubing (several diameters) for finishing cable ends. 22ga /300V wire in several colors (25 and 100ft rolls, partially used, a couple new). If you buy both the items above, I'll throw in all this misc stuff for $25. Good deal if you're at the beginning of a build, as you'll need extra terminals and wire and spend more than $25 just for those.
Also a new 6′ replacement cable, green wrap, for use with a temperature probe. http://www.theelectricbrewery.com/custom-temperature-probes Paid $35 new plus shipping. $25
2 SSR relays; one 30A double pole, double throw relay; Amp meter/50A shunt, heat shrink tubing (several diameters) for finishing cable ends. 22ga /300V wire in several colors (25 and 100ft rolls, partially used, a couple new). If you buy both the items above, I'll throw in all this misc stuff for $25. Good deal if you're at the beginning of a build, as you'll need extra terminals and wire and spend more than $25 just for those.