First is it possible? Im looking to weld 1" and 1.5" triclovers onto a 25 gal megapot from Northernbrewer. I just dont want to tear the side of the pot.
well im pulling a tc from the inside, and welding a tc to the otherside outside the kettle. Its just much easier to weld them together and guarantee and sanitary fitting. I have done it on a keggle no with problems. Just on a thicker megapot it concerns me.
It should be fine. I can't imagine the megapots are any thicker than sanke kegs (did not fact check this), but it has been successfully done on those, take a peek at the soldering stainless thread