Connect Two Taprite CO2 Regulators In Line?

[xRapture]

I'll be kegging for the first time in the next week or so, but I'm getting ahead of myself and wondering if it's possible to link two Taprite 3741 Primary regulators to each other? I've got two kegs, two 3741's and one CO2 tank.
I've got one dual gauge and one single gauge regulators. (See attached)

Is there a pipe fitting that I can use to connect these together and serve two kegs at once?
Thanks!

 

[ImNoExpert]

Something like this?

 

[xRapture]

Something like this?

Is it that simple!? I had seen similar fittings, but I wasn't sure if that'd work, hence this thread.

 

[agrazela]

According to this parts breakdown of the Taprite 3741 primary:
http://d163axztg8am2h.cloudfront.ne...c523a91919a911fe4708fae/3741-br_catalog_b.pdf

Both the gas in and hi pressure out are left-hand threads. (Pretty standard on primaries)

So you're going to need a nipple that is 1/4" NPT male LHT on both sides, like for example one of these:
http://www.homebrewing.org/Taprite-Hex-Nipple-14-LHT-x-14-LHT-_p_5878.html
http://www.beveragefactory.com/draf...ry_beer_regulator_connector_nipple_left.shtml
http://www.ritebrew.com/product-p/843646.htm

 

[xRapture]

According to this parts breakdown of the Taprite 3741 primary:
http://d163axztg8am2h.cloudfront.ne...c523a91919a911fe4708fae/3741-br_catalog_b.pdf

Both the gas in and hi pressure out are left-hand threads. (Pretty standard on primaries)

So you're going to need a nipple that is 1/4" NPT male LHT on both sides, like for example one of these:
http://www.ritebrew.com/product-p/843646.htm

Wonderful! Thanks so much! Placed an order just now!

 

[ChaddyWa]

Reviving this old thread! Do you think this fitting would be too short to connect two primary regulators? Looking for a longer one, but it’s the only one on Amazon.

https://www.amazon.com/gp/product/B003NXYB5Q/?tag=skimlinks_replacement-20

 

[ddibbern5]

If connected to primary you will need left handed threads.