Beer Towers: Standard bolt pattern?

[Gizzygone]

I’m curious: do the standard beer towers have a standardized bolt pattern?

I’m considering purchasing a kegerator with a cheap tower/Tap setup. I’ll likely upgrade to some Perlick taps (since I won’t be drinking the beer daily), but I don’t want to go crazy off the bat.

So: I was thinking I’ll mount the included tower to my bar top and then upgrade after the holidays: but I don’t want to hack up my beautiful bar top if there isn’t a standard tower size/bolting pattern.

 

[jschein]

You don't need to replace the tower just the taps. I replaced an old tower and the screw holes were the same.

 

[Gizzygone]

You don't need to replace the tower just the taps. I replaced an old tower and the screw holes were the same.

The tower that came with mine is cheap: I’m looking to replace it with a stainless model I think.

Then again; I’m starting to see the Black Iron Pipe DIYs and getting ideas...