Ball Lock/Pin Lock dual disconnect?

[Wiesty]

Anybody know if its possible to have a dual c02 disconnect set-up coming out of a c02 tank? I have some kegs that are pin lock and some that are ball lock and I don't want to switch lines all the time when carbonating.

 

[chickypad]

Not sure I understand the question, if you have a manifold you can set up as many lines as you need with whatever combo of disconnects that you want.

 

[dyqik]

Or just use the flare nut hose barbs on the lines and swap out the pin lock and ball lock connectors as needed. Only takes a few seconds to do, although you will need to shut the gas off from the other end of the gas line.

 

[mucci2k]

Or just use the flare nut hose barbs on the lines and swap out the pin lock and ball lock connectors as needed. Only takes a few seconds to do, although you will need to shut the gas off from the other end of the gas line.

This is the direction I'm going just in case I pick up a couple pin locks, I can switch out the connecter easily. I also plan to keep an extra long line, with threaded connecters, to reduce foam for when I do a Hefeweizen and bump up the pressure.

 

[Auger]

Or just use the flare nut hose barbs on the lines and swap out the pin lock and ball lock connectors as needed. Only takes a few seconds to do, although you will need to shut the gas off from the other end of the gas line.

This is also what I do. All my lines have flare nuts and I just attach whatever appropriate connector needed for the particular keg I'm hooking up. I have both types.

 

[DrunkleJon]

You could put a wye barb on there to fork a gas line, or use a manifold. Manifolds are nice in the effect that you can shut off individual lines to keep leaks down (and prevent backflow) though more costly.