Another Grain Mill

Below are pics of my my new MM3 and my homemade base and hopper. I made the base out of plywood and hopper out of 3/4" pine. The hopper is made so it slides over the MM3 and doesn't need to be permanently attached, making it easy to clean and adjust. The hopper holds just over 15 lbs of grain and seems to work real well.

How does my crush look? The mill is set to factory specs (0.040)

Thanks

Bob

I assume you used 3/4" because thats what you had around? Seems like overkill

Very beautiful though, makes me reconsider if i want to build a small box for mine to put the bucket in or just do something like this.

Yep, I used some scraps that I had laying around. I was going to use some old plywood, but the piece was too big and did not want to waste it, It was a fun project.

How does the crush look? Not too fine?

Go Big or Go Home!!! Crush looks fine