Search results

I had tried settings for all type of thermocouples and all behaved the same. My new type K had a red and blue. Blue ended up being the negative, or at least went to the pole labeled negative. I am thinking there's a lot of variation on these TC's.

I received the new TC today and hooked it up and it WORKS!!!! My guess is the TC's i have use a different voltage, ohms or something like that.

PT100 is the rtd setting in mine.

Setting is called INP and it's set for y, which is the symbol for k type sensor. Setting after that one is called P 3.00. p= off i appears in the manual. Thanks for the suggestion.

Nope original wire none added.

I bought a New PID. Same model TA4-SNR. Hooked up, default settings, and same problem. checked settings and all as i think they are supposed to be. Tried all the thing I had before again and no change. So it seems either my wiring or thermocouples are broken, or some setting Is set...

No I did not extend thermocoupler wires. I have it set up to correct type K. I have tried 2 different sensors, and wired them both possible ways for each. I know the thermocouplers work because I used it for another temp controller. I'm guessing I may have a bad PID.

Yes I set it to K as it is defaulted. But I also tried it with each other setting and none work.

3 images 1st is Back of PID showing red (-) at 7, and white at 8 2nd is face of PID showing high temp after i warmed it it went from 216 starting to this temp 3rd is the Diagram on the PID.

I have built a RIMS 120v single element Temp controller using: TA4-SNR - PID Ruike Electronics Industrial Ltd. SSR-60DA - SSR Same as Fotek K type thermocouple - tried 2 different and getting same issue I have wired the system and all seems to work correctly except the PV or measured...

SOLUTION FOUND. I have built a RIMS 120v single element Temp controller using: TA4-SNR - PID Ruike Electronics Industrial Ltd. SSR-60DA - SSR Same as Fotek K type thermocouple - tried 2 different and getting same issue I have wired the system and all seems to work correctly except the PV or...