Search results

Refreshing, dropping price to $80...any takers?

Refreshing...any takers?

Refreshing...any takers?

Sold

No problem...send me a zip code and I can get an estimate. For private messaging, hover over the username and use "Start a conversation." I sent a PM to you as well, if you want to reply to that. You'll see the little mail envelope in the upper right when logged in...how to get to you messages.

Refreshing...any takers?

Refreshing...any takers?

The coil is 7.125” diameter, though the fittings stick out 3.75” and 3.25-3.5” for the higher and lower ones, respectively. The height of the coiled section, 17 turns, is 8.375”. The height to the top of the higher fitting 14.25”

The coil is 7.125” diameter, though the fittings stick out 3.75” and 3.25-3.5” for the higher and lower ones, respectively. The height of the coiled section, 17 turns, is 8.375”. The height to the top of the higher fitting 14.25”

A recent upgrade has left me with an extra 304 stainless steel coil that may be your opportunity. Coil is 32' feet, 11 mm outer diameter (~7/16" inch) and 9.5 mm inner diameter (~3/8" inch), ends capped with sanitary fittings (1.5" inch Tri-clover/Tri-clamp/TC fittings) Coil was originally...

Used sanitary fittings, 1.5" inch Tri-clover/Tri-clamp/TC with 1/2" inch (outer diameter) barb $6 each for straight barb, six available $8 for 90º elbow barb, one available $40 if you buy the entire set Will ship, buyer pays shipping

Likewise.

@TxBrew thanks for nudging the adoption of an avatar!

I am in and would LOVE to win.

I was able to get some information from Brewers Hardware about the burners I bought from them. They wrote, "The 11” WC is for LPG. The NG burners are the standard 7” WC most all homes have for NG. The manufacturer says this: This low pressure burner that measures 10” in...

Thanks JonW. I agree with your interpretation. I was looking for a few reference points to give me some direction on what to set me outlet pressure to. I want to dial that in first, and that should put me in a good spot to try the air assist. Thanks again!

JonW, bsent has indicated NG pressure of 7" WC. Have you measured what pressure NG you have going to your burners?

I am using the BG-14 type burner that I got from Brewers Hardware with NG and am using their NG valve/orifice, which has a 1/8" ID. On their site, they report these are designed to run at 11" WC and will produce 60,000 btu; whether this is for NG, LP or both is not clear. I control my burners...

I am looking for some insight and wisdom about how to get the most out of the BG14 burners on my rig. I am using the BG-14 type burner that I got from Brewers Hardware with NG and am using their NG valve/orifice, which has a 1/8" ID. On their site, they report these are designed to run at 11"...

Resuscitating an old thread here, but I am looking for some insight and wisdom about how to get the most out of the burners on my rig. I am using the BG-14 type burner that I got from Brewers Hardware with NG and am using their NG valve/orifice, which has a 1/8" ID. On their site, they report...