Search results

I like this. I will explore this if I need to. Thanks!

Interestingly, I have a pretty crazy setup in my garage where my garage router and RPi are right next to each other. So I had hoped it would help. But it doesn't seem to be doing the trick. I will try this repeater route and see if that works. Otherwise I will have to get more creative!

Ahh interesting, okay. My Fermentrack RPi is about 2 feet from the fermentation chamber. What you described is what I was trying to use the TiltBridge for. I will try for find the repeater firmware and try that instead and see how it goes. Okay, thanks!

Hey all, I have a strange problem. Long story short, but chest freezer seems to be acting as a faraday cage and not allowing my Tilt signals to get out... Slightly longer... I replaced my chest freezer fermentation chamber a few months ago, and since then I haven't been able to log Tilt gravity...

Thanks!

May I ask what your mash schedule was?

There is a parameter in the setting under Configure Control Constants that sets max fridge temperature. You will need to increase that.

Well, if when you are able to wade through everything I would certainly appreciate a summary or at least some best practices :D

Hey all, question for the team. This post is nearly a a decade old and 8,000+ posts long. Is there a more recent post that summarizes the best practices for setting up the most recent iteration? Absent that, can anyone point me to an approx. post number where I should start reading. I love...

I do, but they are different. I enjoy both immensely. The GL version to me tastes like a Christmas-y IPA, while my version is like a Christmas cookie amber. A little hard to explain, but that is the essence. My version of Christmas Ale started off with this recipe as a base. However, after...

I make a similar beer every year with ginger, honey, orange peel, vanilla, and cinnamon. It is not an exact clone of the GL version, but it is excellent.

Ahhh thought more about it. No. I have the LCD connected to 5V Vin and the I2C pins are getting 3.3V signal. Is that what you mean?

Hmmm I haven't exercised my EE degree in a while. Like a pull-up/down resistor? If so, no. I have the LCD hooked-up like this pic: Edit: This is not correct, as I noted below, I am mixing 3.3V and 5V. I will grab a level shifter.

One last question: I got everything working and so I got ambitious and installed a physical i2c LCD screen. The screen works and displays the correct information, but it does not update. It displays whatever information was on there at startup. Any idea why this might be the case?

@Thorrak thank you for all of your help. Between this thread and the ESP8266 thread, I was able to replace my Arduino controller with an ESP8266 and get everything working exactly how I'd like. It took a little trial and error, but everything is great now!

Thank you!

Yes, this was the largest issue. All of this feedback was very helpful though. Thank you!

I picked up a LOLIN D1 Mini V4.0.0 ESP8266 and am planning to replace my Arduino BrewPi controller. However, I cannot for the life of me find a pinout/hook-up diagram for the temp sensor bus, heating and cooling pins. Does anyone have a pinout or hook-up diagram for the most recent generation...

99% sure I am running the BrewPi remix.