Search results

I swapped a few of them out awhile back. Honestly I think its the controller on a whole. We have had to flash the drive twice and have had a few other issues with it. Our previous generation hosehead was great and had no issues for years until the brewery took a power surge and it died. This...

This is how I inject anything into a keg, usually gelatin. It works well and is easy. make sure you have the available space for the liquid your injecting. otherwise it can be a mess if you need to pull the prv to get everything in the bottle. Generally I found that if the bottle is a 20-25...

Thats a good question. I just assume they don't work well. I have probably 50 batches on the system since that post and the probes are still all over the place and require calibration every batch.

$110 shipped

I would not put the probe between your coils you want to have the probe a few inches from your element to get a more accurate reading of the wort. The element itself will be hotter than your wort and if it touches the probe it would interfere with your boil. I use standard elements in a 15g...

Ordered the parts to attempt to recharge freon. will be about $45 if it works. Borrowed a multimeter and all components that i could test seemed fine. stopped by lowes and every single either chest or upright freezer is sold out. crazy times...

Im not seeing anything that looks like a leak puddle. there is a bit of corrosion build up a bit like what you see on a car battery on one of the copper pipes connected to the compressor. Have you refilled freon before? this video makes it look pretty straight forward and about a $50 investment.

From what I have read if the unit is low on refrigerant that means there is likely a leak somewhere. Is that right? I have a nice oak collar it and the same unit assuming it is the same size still is running $500 with all the end times buying lately. It is arguably worth fixing based on cost...

Here are a few bad photos. Its on and has a rattling compressor noise. when I push on that gray box the ratting dies down a bit

Updated with a bit more information up top.

Updated with some better information. Maytag MQC1552TEW01 mfg 6 years ago The unit stays about 45° and there is a light ice ring around the top front. The compressor is very warm to the touch and there is a working hum when the freezer is "running". When I unplug the freezer and plug it back...

All your standard hops pair well with it. I have used it a fair amount for work. It’s a good complement hop and it can shine solo. Go with classic “C” hops and you’ll get a nice dank iipa

I made a starter of two older packs of this yeast strain that we had in the cooler at work. It smelled bad and I dumped it. Could be that it stink on the stir plate I have had a few strains that were unpleasant smelling starters. I however remember this particular stain smelling rotten when i...

Blue and black sold Green is left

I have 3 Tilts for sale 2 are unopened and 1 has be used a couple times. These things are cool but didn’t do exactly what I wanted. Looking for $115 each.

for rye to shine you want it to be about 20% of your fermentables. I would think it would work well in a graf

I built a 30a 2 vessel kit from ebrewsupply for my system 4 or so years ago. It is great and I have had no issues with it. That being said I am looking at some of the other less expensive units for a biab setup.

If you already have fermentation control of some sort I would move into kegging. It will give you more joy than the glycol. Glycol is really just a end of hobby toy in my opinion. It doesn’t offer anything that a freezer can’t offer other than possible space savings. I have a glycol...

If you have an instapot you can put all your parts in there and "autoclave" them for 10 minutes. Some plastic and rubber handle parts on cheaper valves may need to be left out.

Dry hop with 1oz fresh lime zest