Search results

How high off the floor is the horizontal mount on the sprayer? I have a window above mine, but would like to get one of these!

The floor is good, but you should have slopped it to the drain. I did that and couldn't be happier... Looking good! I like the sprayer... Wish I had one.

I'll trade you ball lock disconnects even up, I have a few sets plastic w/stainless rings... I have switched to all pin locks and don't have a new for the ball lock ones.

Well said. Ever try and see if it works? I don't believe everything on the Internet...

Use your drill press with a hole saw...easy as pie. No need for extensive blocking and clamps. Just get a second set of hands to hold her in place.

I ran 2 50 amp lines from a 100amp sub in my detached garage.

Find the holes they are getting and plug them. Unless you have lots of kids leaving doors open I bet you have a hole somewhere....

I don't use insulation or lids on my sankes...has worked well for the last 18 years and thousands of gallons of really good beer.

We are close to $0.07/ KWH in MN.

So.... Total price paid?

Just scrub the whole interior down with a sloppy slurry of bar keeper's friend and a 3m green scrubby.

I used nothing on my hard maple mash paddle, looking good after a year...I also use a stainless spoon in the boil. I wouldn't stir the wort in my kettle with it.

Price???

My brew house is in a back room off my detached garage. I have in floor heat and AC in there for fermentation temp control... Cleaning the kegs I use as fermenters is easy, some hot water then a little oxy-clean soak for a day, then about two gallon of water to boil/ steam sanitize...drain and...

Picture from my brew house tonight.

I use a 3800w 220v element in an uninsulated keg for 14-15 gal boils- down to 12 gallons after boil. No controls, just plugged into the GFCI outlet.

$100 for the solder...here: http://www.amazon.com/gp/product/B001HWDPS4/?tag=skimlinks_replacement-20 If I needed it this would be a good deal.

True, but if mine does leak into the box, I doubt it will leak out as everything is gasketed on the NEMA4 box. Most probably, it would trip the gfci... I do not like the JB weld design, relying on a chemical bond or the PVC cap relying on friction for safe coverage of the exposed wires. I...

Correct, but I am able to replace the element quickly an have no concerns around leakage. I was able to torque the element/ o ring/ box assembly down really tight using a socket and breaker bar. There is no chance on leakage as this is really tight. How tight is yours if you are spinning the...

I soldered the SS nut to the keg wall and then screwed the element into it. The element was first, then a silicone gasket then the SS box then the SS nut. The element is removable and sandwiches the box onto the keg- no welding.