Search results

Its at 0.024" now, I plan to increase it before the next use. I replaced the screws that adjust the roller with thumb screws. Just hand tightening them wasn't good enough which widened the gap considerably. I readjusted it but its a bit too small. I was just planning on removing enough...

I bought a 2'x3' stainless steel table to use to mount my motor and grain mill. It has a support underneath the center of the table. This is where I am planning on mounting the motor and mill. Would removing a six inch section of the support be a bad idea? I would need to remove it for the...

Are the certificates mailed to the people entering? I just logged on to https://brewingcompetition.com/index.php which has a link to a gold certificate for my entry #22906 at Nashville, TN. Also I still haven't received the score sheets. My address is still the same as it was when I entered...

I wasn't planning on driving, just that I could get some really fresh yeast from there, and shipping shouldn't be too bad.

Does anyone have any experience with RVA Yeast Labs LLC? The company is a 2 hour drive from where I live. Plus they include 2 billion yeast in their bottles.

Sent my beer in a few weeks ago.

I have encouraged a few friends to get into homebrewing.

Anyone get score sheets from Tennessee yet?

Stopped by the store earlier today. Even more impressed than the pictures. Its easy to get to, nice selection of ingredients, and knowledgeable owner. Hope you do well, I'll definitely be a return customer.

He already does.

Very nice looking store! I'll probably stop by there sometime this week. There is a store about 1 mile from where I live, but it has very little amount of ingredients.

The link for the motion dectector on the User Add-ons page of the RaspberryPints website no longer points to the correct address. You are now sent to the beginning of this thread. The correct link is https://www.homebrewtalk.com/showpost.php?p=6029665

Some of the numbers are unreadable, but the wires are labeled: 1-Black 2-Brown 3-Blue 4-Grey There is also an unnumbered green/yellow. I assume: Green/yellow goes to ground on my switch, same for green from power source Black (from power source) goes to the switch ( near the off position)...

I purchased an Power Grind motor recently. Just want to make sure I am following the directions correctly. This is what is included:

Thanks for you help, never thought to check if I had switched pin 6 and 9.

Yes I removed the 3.3v pin. The first one I soldered. This one I am testing step by step. I'll solder the wires to pro mini as soon as I get a chance and test it again.

Yes I have download the driver. I have both linux and windows so can upload the sketch using either. I have uploaded the sketch using Arduino Uno, but wanted to make a cable similar to the one in the manual. Thanks for your reply.

I am trying to assemble the Arduino pro mini and CP2102 using the manual on github. I have set the program to using the board Arduino Pro or Pro Mini (5V, 16 MHz) 2/ ATmega328 on COM3. I dont get a response when I go the serial monitor. The first time I assumed I had ruined the board. But...

A tank larger than 20 lbs also helps keeping it from freezing. I use to keep my 20 lb tank in a plastic trash can I cut in half. When it is cold I poured some room temperate water in the trash can. It helps, but a larger tank is easier to work with. Also a tank that is almost empty will...

Scored 2nd at the Belgian Strong Ale table.