Search results

I recently moved to a new apartment. Previously I would remove the aerator from the faucet and connect a male quick disconnect. I would connect the immersion chiller to this to cool and also fill my brewing vessel. The faucet is much nicer, but does not have the regular aerator to replace...

I take it to visit friends.

One year old Flanders Red with Wyeast Labs #3763 Roselare Belgian Blend

I'm in

I'm in

I'm in

You can set a static ip by ssh to your raspberry pi and editing dhcpcd.conf sudo nano /etc/dhcpcd.conf Adding the following at the end: interface eth0 static ip_address=192.168.1.105/24 static routers=192.168.1.1 static domain_name_servers=4.2.2.2 4.2.2.1 interface wlan0 static...

I've been having problems getting readings using my Raspberry Pi also. I'm almost positive there has been a change in Raspbian or firmware that has lowered bluetooth reliability. If I use the app on my phone I can pick up the signal from the Tilt in another room. If I use the raspberry pi, it...

I'm in

Happy Fathers Day

I'm in

I'm in

sold

Finished the stand for decoction mash/soda/bochet

Nice job on the stand! @rubiconbrewer Where did you get the end caps for the square tubing? Those would work great on mine. Originally was going to weld some 1.5" square pieces to cover the ends but didn't think it was worth the hassle in the end. Here is a simple picture of how to mount the...

Added some black pipe for propane.

I agree with this, Greenlee step bits make a huge difference. Much easier to drill and less burrs to remove.

The first use of the stand. Was so much easier to setup than the 200+lb wooden stand.

Its a heat shield from Brewers Hardware.

The top part of the wind screens move back (did that right after I took the picture). The VESA mount holds my control panel. There's a few minor adjustments like tightening the VESA mounts etc but that will be done this weekend hopefully.