Search results

Have you tried to tighten the bulkhead more? I would take the barb off on the inside so you can use plyers to grip the coupling piece better and then tighten from the outside. It does not look to me like the oring on the inside is being compressed enough by the washer.

I just have small pvc to have the wire rack sitting on, just to bring it off the floor a little. No air flow in the PVC for mine.

If you are sticking with a plastic cooler for mash and looking to use an electric element, why not do RIMS tube? That way you do not have to worry about loosing room in cooler or accidentally melting plastic! Bobby from BrewHardware sells some good RIMS tube setups, along with heating...

I tested the starter and it was still good, definite Belgian flavor profile! The only smaller container I have to ship is the actual container that yeast was shipped in! PM your shipping info and I can get that out with an ice pack or two to make sure it makes it in good condition. I would...

I used this foam tape, if I remember correctly I put down two pieces for a nice wide piece of foam. https://www.amazon.com/gp/product/B07KWTP5RR/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

I have my Craft Culture Eagle River Ale Yeast II spun up now in a starter, let' see if it is still good. I think I still have some small yeast containers that I might be able to use for possible shipping.

Got a brew day in yesterday, and the ICQUANZX T-Display ESP32 WiFi and Bluetooth Module Development Board for 1.14 Inch LCD was delivered as well! Could not flash right away due to driver issue with Win10, came across a Microsoft page for drivers - I used the Silicon Laboratories Inc. - Ports -...

@UncleD Thank you much for the offer! I should have come back hear to post that @LBussy has offered to help me out!

Lee, I have my first Tilt coming and I went with the ICQUANZX T-Display ESP32 WiFi and Bluetooth Module Development Board for 1.14 Inch LCD that you linked to previously. I was also looking at the case that you linked to, but I do not have a 3D printer. I did try a local company that allows...

LOL, not UP! More in the North of Detroit area.

I have the kegland 5L mini keg and have no issues at all with it. Yes the pickup tube it comes with is not stainless, but you cut it to size and I have had no issues with it not picking up to the bottom. It is on you to ensure the length is good though. I use it mostly for travel and share...

Welcome and have fun, I started right with all grain as well! SE MI as well, North of Detroit.

Welcome and enjoy! SE Michigan here!

Depending on where you are at I might be able to help. I am not looking to ship though, so you would have to be near south-east MI.

Go to brucontrol.com for the manual. It will not cover changing over from another system though.

" Top Cap or Tri clamp sold separately. (Contact us for Top Cap) " So does that mean you get no lid and nothing for the tri-clamp at the bottom? Start adding those items on and that price goes up quick!

Good set of videos, like always with you! Off topic, but your earlier videos on wiring a control panel were very helpful for me when I did mine! Thank you for the support you provide to the home brew community!

Looks like both links are to the blichmann grain mill and not the anvil conical.

Sorry, had to share. Catching up on this thread and when I read this I originally read it as Brass Monkey!!! Of course then the song became stuck in my head as I reread it as I knew brass monkey was not right. :off: Now back on topic, I replaced all my gas side duotight 1/4" flare fittings...

I have the foam seal on the bottom of my collar so it is not connected to the freezer, if there is a need to turn it back into a freezer. You can see it on the second picture.