Search results

The Tropic Haze NEDIPA - All-Grain Recipe Kit looks interesting. Count me in!

Awesome! I'm in, thanks for the opportunity.

Throwing my name into the hat. Thanks!

Yes please...

They're running on high pressure. I plan to change the HLT & MLT to low pressure and install a HERMS coil, gas valves/pilots, etc. My boil kettle will still be at high pressure though. I had planned on running a few batches with the direct fired MLT before I switch to HERMS just to...

Makes sense. I think I'll look into some heat shields. I think Brew Hardware has some decent heat shields on their website. Maybe I'll try those out. As far as the reflectix, maybe I should just go full bore and install a HERMS coil and automation to my setup and forget the insulation. I had...

Hello. I just finished building my weldless single tier brewstand. Ran it through a test run today, and I melted the reflectix insulation and the test water in the sight glasses was boiling. Could this be due to my BG14's being at the wrong height? They are mounted 3" below the deck of the...

Count me in!

Count me in! SkeezerPleezer's Three Floyds Zombie Dust Clone - All-Grain Recipe Kit Please and Thank you.

Thanks everyone. TSP solution, Hot PBW, then a good rinse followed by a Starsan solution it is. Thanks again for your help. I cant wait to finally fire this thing up!

Hello all. Finally, after years of building my brew rig (with the birth of my 3 children in the meantime to detour the process) I have finally finished. Thanks to a friend at work who did some awesome sanitary welds for me, and the guys at Brew Hardware and NorCal Brewing Solutions for their...

I started brewing after my cousin brought over some homebrew. He was very much into craft beer/homebrewing and I was an avid Bud Light guy. He turned me on to the craft of homebrewing and I've never looked back. My taste in beer has improved dramatically. So has my homebrewing skills. I enjoy...

Welcome from Eastern MA (Lynnfield). My story is quite similar to yours. Started with a Mr Beer (which I also butchered). From there, I went to a Brew Your Own type facility which was awesome and opened my eyes to brewing. I went on to extract brews at home and finally finished building my...

Hello from Lynnfield MA.

Welcome from Lynnfield MA.

Count me in!

I'm sure this has been answered somewhere on this forum before, but I've searched and haven't found the info I am looking for. I am building a single tier brew rig out of slotted angle iron. I am using 3 keggles and 3 Bayou Classic BG14 banjo burners. Has anyone built a similar set up and...

I have a keg with the top cut off and 3 couplings on the bottom end of the sidewall with a ball valve, a temp guage, and a sightglass installed. I was wondering if it would be OK to drain from the coupling on the bottom of the sidewall or if the diptube would be necessary to drain the HLT to the...

Thanks for posting. I am building a rig as well and was wondering the same. I will keep an eye on what everyone has to say. I myself am running 3 burners.

Hello. I am in the process of putting an all grain set up together. Is there any benefit to putting a diptube in my keggle HLT or can I just drain from the coupling with a valve on the outer end? I havent brewed all grain yet, but I am under the impression that the HLT is just to store/heat...