Search results

Can't say I know for sure but 1/2 inch seems kind of close. I think you want as much room around it as possible for better air flow. Maybe someone else has some advise on placement. In my case it is on the side with the heat sink sticking outside the top of the panel. I don't have a fan but...

Take a look here. http://www.instructables.com/id/Electric-brewing-system/step6/Understand-the-wiring/ The second drawing is what I used with the only difference being the PID. I'm much more comfortable helping with it as opposed to the 220 circuit. If you don't have a good basic knowledge of...

No problem. I noticed from your previous post that you are using a 110 circuit. My setup is 220. The PID wring should be the same but the element would be different.

Took a few photos this morning but must say it is pretty hard to follow.. I decided to do a drawing as well. Hope everything makes sense. The switch is a DPST used to turn off the power to the element.

Sorry.. GFCI.. I'll try to get some photos tomorrow.

I used 10/4 stranded from gfic to the panel and then 10/3 stranded to the element. Inside the control box 10 gauge copper.

I have the same PID and SSR. I've been running it for about two months and it works great. The wiring diagram I used for mine came from this instructable. http://www.instructables.com/id/Electric-brewing-system/ Since I don't have a pump in didn't bother with a 110 but I did add a double pole...

Long stainless steal spoon. Marked it with a Dremel. Same spoon I use to stir. One less thing to clean.

No stickies left in Equipment & Sanitation

Not here either.. Equipment & Sanitation McMaster O-Ring List This Is How Big Your Mash Tun What Sanitizers & Cleaners Are Used

Working on those now.

These are done. Nothing... Recipes And Ingredients

Not here. Malting Gluten Free Grains

Not in Electrical Primer For Brewers

Didn't find it here.. Beginners Beer Brewing Forum > Recipe Formulation & Ingredients Descriptions Or here.. Beginners Beer Brewing Forum > Fermentation can take 24 to 72 hrs to show visible signs.

Not sure if you figured this out but I just finished a system using this pid. The way mine works is the the SV reading is the temp you are trying to achieve and the PV your actual. The Out1 is the main burner and will flash depending on the % of power applied. If you press the Set key it will...

Yes. I have a switch just above the power out.

Ended up going with the Mypin. Took a little time to decrypt the directions but it worked great

Just completed the first brew using my new ebiab system. I based it on mrBippers http://www.instructables.com/id/Electric-brewing-system/ and of course http://www.theelectricbrewery.com/. I couldn't have gotten this far without all the great info on this forum. Anytime I got stuck or needed...