Search results

Does anyone know a good place to find brewtroller tutorials? I have searched their website and downloaded the manual, but it doesn't have much information about specifics. I am currently in the design phase and would like to order as much of my parts as possible before I begin to build. I...

I wasn't planning on using relays for my valves. I might just have to go with brewtroller outputs and resistors.

How did you wire your switches, maybe I could modify that for my application? Did you have to do anything special to get the touchscreen to work? Is it running on pi or just windows? Thanks

Nice stetup! Are the lights always on while the pumps are in auto, or only while the pumps are running? Also is the screen a touchscreen? Thanks

I am in the process of planning my Brewtroller build and had a few questions. I have already purchased a Brewtroller and 3 RGBIO8's to control the led's for the lights of the switches. They will tell me if the switches are in the on, off, or auto position. Is there a way to also have the...

Thanks! Do you know if there are any software limitations to the number of taps?

I was planning on a 10 or 12 tap system, but did not know how many pins where available for flow meters and or if there was a software limitation on the number of kegs you could list. I was planning on using a large computer monitor in the portrait direction.

Is it 8 or 10 or 12? Does anyone know the max that will fit on screen and the max for flow sensors. Thanks

How many will show on the screen as well? Thanks

Does anyone know the number of taps the raspberry pints supports? Thanks

Electric is way cheaper for the same amount of control as gas. All you need is a heating element, inline gfci breaker, and a heavy duty motor switch for the most basic installation. Simple off and on. Where electric gets more expensive is when you add all of the nice automatic temperature...

Please count me in!

Any updates?

Search google for restaurant auctions in your area. I have one local and have got great deals from restaurants going out of business. http://www.fastkitchenhood.com/ sales new custom made evaporation hoods at the best prices that I have found, but the are still pricey.

They have a ton of them, you wouldn't have a model number or a thread where you explained them? Thanks

John Blichmann wrote an article for the November 2012 issue of BYO magazine that summarized ventilation requirements as follows: Electric based brewery: Divide the element size (in watts) by 17.6 to obtain the required CFM (cubic feet per minute). In our case we use a 5500W element in our boil...

Any suggestions on a sensor? My setup is a 15 gallon pot 19.4" tall with the port installed ~1" from the bottom. And since the brewtroller is basically an arduino I should be able to configure this to work with it.

Do you have any pictures of this, I would be very interested in this setup? Sounds like a much better approach. I'm somewhat unclear on how to keep the air pocket. I'm hoping I can install a tee where my temp probe will be and not add another hole.

I'm not too worried about the slight difference the specific gravity would make, I kinda figured as much. And the hydro-static pressure sensor is genius, I would like a little bit more portability and I have the brewtroller where the bubbler has already have code for it. Has anyone tried the...

Is Anyone using a bubbler to measure volume in your mash tun? I am in the process of designing my new herms system with a brewtroller and was going to install fittings for the hlt and boil kettle for volume measurement, but I did not know if the the grain weight in the mash tun would allow the...