Search results

Set up and chill down two hours before event. Vent off keg and set regulator at 8 psi and increase as required. Open tap all the way and tilt your glass 45 degrees to start pours. It should stay around 38 degrees. I stack two 5 gallon pails with bottom cut out of one and line the inside with...

I use pool noodles to insulate my lines from iced tub to my cooler with plate chiller on ice. Works great when touring in Texas and Arizona in the winter. Are you using a chiller or just a picnic tap?

What beautiful wood. Nice to see a light collar for a change! Nice touch.

Do you need a collar for clearance? You could drill holes in back of lid and use rubber grommets to protect the lines for outside CO2 , power if you want internal fan and a controller temp probe. All can be done without a collar. I can send you a photo but do not know how to post one..Then...

I use a syringe with star san and slots cut in the sides of end with an exacto knife so when you push down on centre it causes star san to shoot and rinse out the connection. I also use this for the dip tubes when I clean the tanks.

I am waiting t o see what others suggest. I would do a octoberfast ale that is on this site!

I suggest taking a pop corn popper and torrifying the raw barley. I pop about 2 oz at a time and the pop just shows a white line along the crack. It will give you a biscuit flavour. What country are you in? I would smoke some barley in a bbq and give the locals a new experience. Stay the course!

Can you send me a pm or post info about your inline hop filter? Thanks

A dremel grinder will do it more slowly and so will a round file or a small half round file. Slow and steady wins the race.

Thanks. I will join the twentieth century soon. This saved me asking my 5 year old grand daughter.

I have never downloaded a book. Could you post a "how to" for guys like me???

Beer is your friend here! Remember you can get more results using honey rather than vinegar. You cannot change what has been done. Give them a six pack and explain your concerns and see what they offer back. Nothing lost and much to gain!!! Remember rabbits chase carrots. Landscapers...

A sink wrench is your ticket. It is designed to fit in a tight spot and turn sort of like a pipe wrench on a long extension. Will work great.

Why not attach a 3/4 inch plywood table top with 3 inch edging and have it on a hinge to your garage wall. ?? It would fold down like ironing boards used to be stored. One set of legs or have two tables folding down and attached against the garage wall when not in use. Think like a camper in...

I have used my plate chiller in Ariona for camping parties for years. I pre-chill my corny kegs by taking the bottom out of a 5 gallon bucket and stacking it on a regular bucket. I then take aluminum core-plast type material or use urethane foam that you would use on a hot tub and put it in the...

I get between 84% and 86% with .030 setting on my commercial farm rolling mill. I am happy.

I tape mine to a suspended freezer pack with insulation aluminum foam between the probe and the tape for my keezer. Works great!

I have extract from same source and am interested if you use it other than initial boil for IBU's. Tips welcome. Thanks

The golf club is a great resting spot for a club to finish off its' tour of duty! Must be a story here!

Tie a butcher cord around the stopper and tie to the hole in the bottle. Fill your airlock with vodka and rinse it out and replace vodka if it pukes!