Search results

Has anybody upgraded a 120V 4.0 with a bigger pump? Is it possible? The bigger pump in the 4.1 seems to be 240V only? I can't tell.

If somebody has retrofitted the new pump onto a 35L (120V at that) I'd love to see a video. Although, if the stronger pump doesn't solve any problems, that's moot. The flow rate of the 4.0 pump is fine, clogging is the issue.

The Gen 4.1 has a new stronger pump so weird that it failed like that. I was thinking about upgrading the pump for my 4.0, but maybe I'll wait.

That's a bit weird. Maybe part of the reason they upgraded the pump for the Gen 4.1? Anybody know if you can put that pump in a 4.0?

Yeah I have done this too. Never had a problem when I was using rice hulls but ran out and now occasionally I get this behavior.

I'm a few brews into my own replacement and the connection is cooler than ever. Seems like a bit of a defect from the factory that hopefully is sorted out now. I got the Gen4 as soon as it was available in my country.

Do you use a hop spider? Rice hulls? Grain crush size? I transfer with the recirc pump myself, never had a problem.

A whole new unit? Feels like overkill and I've already ordered the replacement parts for ~$20. Although I see yours took more damage than mine.

Just had a similar meltdown on my Gen4 last night. It's my 70th brew on it and no complaints but I have noticed the plug getting hot from time to time (on max boil of course). However last night was something else as I could definitely smell something burning. The brew completed fine but I...

That doesn't work for me at all. I've used it maybe 5 times so far. No way I can get it properly secured around the re-circ pipe and attached to itself. Usually it barely holds on and the re-circ pipe isn't really covered.

I have the same issue, it's annoying. One of those things that feels like they didn't even test it. Make it 1 inch longer...

I have done about 50 brews on my 35L Gen4. Only once did I have water shoot out the side of the mesh, and that was partly because the mesh bottom wasn't seated properly. Thankfully mine has the second set of feet so I use that to let it drain for a few minutes. However I sparge with it at the...

I have done this as well but don't have a lot of fridge/kegerator space. Do you think it's ok to pull out the spent keg and leave it sealed closer to room temp for any length of time?

There are instructions in the manual on reconfiguring the T junction. The manual says this would allow the tap to train even if there's a blockage in the pump. The downside I see is that you'd have to rely on gravity to drain rather than a "quick drain" by turning the pump on, which I like to...

I have started using the top screen on the malt pipe for sparging, I think it distributes the water quite well, and you can give it a "push" at the end to squeeze more through the grain. Quick disconnect for your water source or something else?

I have been using corny kegs to ferment and serve for a while now, it's working well. I went straight to floating dip tubes (with a filter on top) and it has been great. I also pressure ferment. I usually let things go with a blowoff tube for about 48 hours then put a spunding valve on and...

One of the reasons I bought the Brewzilla was to get away from BIAB! :p

Any recommendations for a thermometer for calibration, and/or future bluetooth use with the Gen4? Is theirs the only one that is supported? Referring to this: RAPT - Bluetooth Thermometer -20 to 300C - 20cm HTC Probe

I also had issues on my first brew but not since. I set my grind to 0.375 and it seems ok for efficiency and the mash itself flowing well.

I also did both of these things and had no issues. I may try to drop the grain crush a little again next time and see what happens.