Search results

Whoa! No Ground? I'll bet no GFCI either..As was said, don't kill yourself..:(

I'm interested to see the answers to this one; I'm having the same situation with a Wit.

I think you have it right. How are you going to handle two sensors? If that's the plan.

I try to keep things stirred up until the wort begins to boil. When you clean from this batch, try a paste of baking soda and water. I've "wet sanded" really bad messes this way.

Hook up the sensor to terminals 1 and 2. 120-v from line to #7 Jumper #7 to #10 Neutral to #8, along with neutral to the receptacle common Power to the outlet from #11 I would use #12 wire, since the controller will pass 16-amps.

It looks like you might be able to fake out the alarm mode to work for you. See table 4; Set the AL1 setpoint for your target temp for the refer unit, say 42-deg. Set the parameter AH1 to the high limit above setpoint, say 45-deg. As for the Bb parameter missing from the controller, I don't...

Don't know the dimensions, but, a section of a plastic barrel?

It looks like your alarm output is on/off. Is there a dead band? If so, this could work for you. A dead band (difference between on/off commands) of a degree or so would make the alarm output function just like the OEM temp control does. This would give you some time between compressor cycles...

You can use a SSR. You need to set up your controller for digital ( on/off switching) operation, not PID. You should also set a minimum off cycle time of a minute or so, to prevent issues with your refer unit. Short cycling of compressors will cause overloads and possible shortened life. You can...

Nice brazing! I'm gonna try it! I know, off topic a bit.. I have some SafetySilv 1200, from my refer tech days. It's 56% silver, lead free, but safe for brewing? I can make some nice joints with it, but don't want to grow a third eye!:D Update; Harris says that the safety Silv 1200 is the same...

I've gathered most of the parts for a single tier all electric rig. I'm good with the electrical details, except, I'm not sure where to locate my immersion sensors. I'm planning to have a HLT with a HEX, Rubbermaid Mash Tun, and a Keggle. I have two March 809's; one for hot water, and one for...

I'd love to win!! Pick me!!

How does crush affect efficiency?

Is this typical of brews with honey?

I have 2 809's without bases. (Synthetic housing) What is an acceptable method to mount the pumps? I'm not using any hard piping. If I did, can the pump hang from it?

Beautiful baby girl..Beautiful name also! Excellent work on the other project too.:mug:

:mug: +1 on the dogs!

How do you use the chiller to cool wort?

Where did you get the shelving?