Recent content by Wildknight65

Great I think I'm sold. Im also upgrading all my kit this week to grainfather. I've watched all the vidoes reviews to death and I'm pretty sold on this kit. maybe a few of you will disagree, but order going in today for the grainfather connect and a grainfather conical

Is anyone using the Tilt Hydrometer and are they any good

cheers guys, i think I'm going to go back to my good old hydrometer, its more accurate it seems

Okay thank you for this, but I'm still a little confussed and glad I've asked this question as i had been using the refractometer without doing any conversions, luckily it was only on this 1 beer, the rest were done using a hydrometer. so my refractometer measured 13 brix as my OG, (i did not...

Hi all Strange one here and any advice would be great. I’ve just finished fermenting a high abv ipa. SG 1064. Four weeks in the fermenter and I have taken a reading with my refractometer. This reading was 1023 I was disappointed this was too high so double checked it with my...

Hi again This problem is driving me nuts now. Disconnected the line giving me problems from the manifold and opened the valve. You can hear a glugging of gas coming out. Output set at 10psi. I expected a steady flow of gas. The second part of the video shows the needles going nuts on the...

Thanks for the reply. I only filled this cylinder 1 week ago so I really hope it's not empty. Even when I connect a full cylinder that dial never moves further than the red section. I've sprayed all over for leaks. Disconnected and reconnected everything and nothing is visible. Interestingly...

Okay so I've uploaded a video to kind of explain the problem. Note the dial to the left starts to drop and once it gets so far it pings back up it constantly does this for a while. I've just added a new keg full of racked beer, added has at the psi shown on the top dial, checked for leaks and...

Lol, I can never get the bloody photos to upload properly

Hi mate, first up COME ON YOU Spurs!! Lol. massive supporter. I found the customer service really good, I dealt with the mostly on Facebook messenger and never had a problem with reply. I was surprised how quick they responded. When you mention blow off do you mean the size of the...

Here is my setup.

Just thought id share with you my experience of this product. Living in the Uk, I'm forever having problems with getting accurate fermentation temperatures for my lagers/ales. I bit the bullet and ordered a Brewjacket immersion pro, from the states. Ordering/communication and payment was a...

Hi there. My keezer has two kegs full with beer nicely pressurised and pouring well at 10psi. I went to connect a third keg this morning with some water and sanitiser, hooked up the third gas line and as I went to turn the gas on at the manifold. The gas started to fill the keg, but the...

Thanks guys, i suspected in could be the keg, i did notice the connector thread was slightly loose, so I've tightened that up, secondly, and this is my bad, i was using grey disconnects for both gas and beer. I've swapped the beer for a black one, but not sure if these connects are the same...

Hi guys. My new keezer I have built was holding a 1 keg at 10psi and has been for over 2 weeks now with my tank 1/4 full. I've attached. Picture. It was just above the red section. Before I added next keg. I've recently added a second keg, pressurised it up and after 5 days the tank dial has...