waynerob11

This is the valve I use - draws no current when closed and is only opened briefly to reduce pressure - had no problems so far

my system is to keep it closed until pressure hits desired level and then activate - I not sure why it would overheat - they are rated...

Pressure is monitored by a pressure transducer on GPIO 3 which activates a solenoid valve with a small hole to release pressure slowly...

Thanks for that - what if I were to replace the two buttons with a PCF8754 and Rotary Encoder - would I have to amend the config.h file...

What bin file can I use with a ESP8266 or an ESP32, to run BrewpiLess, with glycol cooling , wire heating and fermenting under pressure

I have three RPi's, one is running Magic Mirror, one is running Raspberry Pints and the last runs Fermentrack - what I would like to...

I should add that screen blanking is set to ON and that the python file has been made executable

Hi Thorrak, I am trying to blank a raspberry pi screen with a PIR, and I have written this script - it runs OK buy only displays...

I am trying with a PIR to blank a raspberry pi screen, and I have written this script - it runs OK buy only displays "display_blank 1 on...

No need to apologise - you must get bored with twits like me trying to get a software controlled fermentation system running

OK did all that and wired TFT as shown - temp OK - relays don't work, TFT doesn't work. looked at buying your PCB but they are out of...

which bin file do I use to flash

ILI9341

The one I have is from AliExpress -...

Thanks for you reply, another query:- Does BrewPiLess V15 support the use of a 2.8" TFT display?