just regular air...max of 35psi.... call me crazy but I'm going to try the epoxy. I did look at BrewHardware.com. but I did not find anything that had 1/8 Female NPT on one side for the sensor. Thanks all for the ideas.
ps. you're probably right about doing the simple fill up the keg with bike...
well i spent a good hour at Menards and came up short
my plan is to use a 1/8 Female (npt) to 1/4 Female (npt) adapter and epoxy the 1/4 Female to the cornykeg quick connect
I'm looking to connect one of the above (which is 1/4 MFL Male) to sensor below which is 1/8 NPT Male.
I cannot find a 1/4 MFL Female to 1/8 NPT Female adapter.
Looking for suggestions?
Thx