Recent content by robguthner

Long shot but Is this still available?

It’s not about what’s left it’s about lifting my 30 gallon kettles to clean them I’m going to be installing a 2 inch tc. Basically I want to see IP and hard pipe my entire system but in order to do that I need a central located bottom drain on my kettle and mashed done and hot liquor tank

Thank you

Nope I want it smack dab in the center on the bottom for drainage

Yes you would know when you went through it layers peel off apparently come off from what I’ve heard.

I know its been a while since you got your port welded on. im looking to do the same thing do you happen to remember the guy shop you had weld it i want to give them a buzz. my welding buddy is not sure about the settings they used to do tri-clad

hey kxavier_23 have you had any success doing it on a pot with tri-clad as the material?

Hey guys just wondering if any of you have any input or have seen anything it’s like this before. I am looking to put a 1.5 to 2.0” tri-clamp Drain fitting to the bottom of my 30 gallons spike boil kettle. Mainly for cleaning purposes that pot is getting heavier and heavier to lift every time...