Recent content by radzieju

Thanks, i will try that.

Thank you. So is this going to be correct:? script name i want to pause is Washcycle If "tempsensor" connected == false pause "washcycle" endif wait "tempsensor" connected == true resume "washcycle" Cant trial and error much because i dont have access to machine, will have to do it remotely...

Hello everyone, I have a problem that I can't handle. I built a keg washer based on an Arduino Mega, which is connected via USB. During the full washing cycle, the interface sometimes disconnects for a moment and goes offline. This causes huge issues because the script continues to run, and when...

There is a pinout at Rocketcontroller.com you can check. As i remember , i just solder a sensor to a leg of button nr2 and IT just works.Button nr1 didnt work.I will be at brewery in couple days , i'ill check.

I ordered mine from their store at aliexpress with no problem.

AC powers the board, relays are powered from internal step down. I only have AC line attached to controller, no need for extra suplies.1wire probe is powered from board also , and analog sensor too.

I have a AC line connected to AC in and same line goes through the relays to power a AC loads , fan, 2 augers and ignitor. They have also nice relay addon boards for this controller in the same factor but BC doesnt work with them (i2c).

For additional input i just solder a connection to one leg of switch that's IT and works as IT should.Its really nice controller. Iam using one to controll my wood pellet burner for boiling Kettle, i threw away factory controller and put this instead. Iam using a 1wire probe, flame sensor...

If someone is interested i bought couple of those lately and they work good. Nice form factor with din mount...

Hi, i finnally managed 1-wire sensors to work stable. IT was noise from the solenoid valves im my fermentors, i had probe wire close to solenoid wire. When i layed the wires far away from each other errors and disconnects stoped. Using a solenoid valves for fermentation tanks was a bad idea...

Hi, i dont have schematics for my build, i used ones from website. Now i have whole box disconnected and i am trying to rewire all , it looks like spaghettis inside. I will rewire DC grounds as you sugested.Ordered some new terminals for connections also for better look. As a USB connection i...

I will need 8 sensors, but im testing with 2 of them for the fermentors. First i was using 4,7k resistor, but changed that for 2,2k. Readings are wrong just after start of sensing. I under estimated the size of control box and bought 16in x 16in which is little bit tight so its packed that i...

Interface is mega board usb connected to windows tablet. Sensors i used before were waterproof i bought from china, i changed them to original dallas chips, didnt help. Power sources are 12 v for mega, 5 v for sensors, 24 v for some sensors, all din mounted. 4 12 v solenoid valves with flyback...

Hello, is not optoisolated relay board can cause problems to 1 -wire temp sensors? I have been struggling to make the sensors work stable, but they disconnects once in couple minutes showing -127 C, I changed topology from star to linear then stubs and they still disconnect. Change sensors for...

Thank you Sir, i will look into that. The spreadsheet works calculating a value for every minute , i put temp value for every cell from first minute to last minute of pasteurization. 1-46-PU 2-46-PU 3-47-PU 4-48 PU etc And its toping it up at summary cell for PU of whole process (15,78 PU )...