Recent content by pughww

The quick connects (valved, seal when disconnected) are from United States Plastic Corp. https://www.usplastic.com/catalog/item.aspx?itemid=118175&catid=743

Here is my solution to getting enough space below the Spike conicals for various hardware attachments and keeping them stable when I roll them around my shop. The wooden stands were made from a couple of 8' 2x4's and one sheet of 4x8 1/2" plywood. I fabricated some simple aluminum brackets...

Great looking set-up! Where did you source your heating pads? Thanks, Brian.

John, Thanks for the kind words. I just read your Brew Rig Build Thread and really appreciated all of the great information and wonderful collaboration from the members on this forum. What a fantastic looking set-up! Brian.

I went with the green wire because I had a entire spool laying around. I didn't have any issue when I was building it because I completed it section by section, but I certainly agree that it will be a pain to trace those wires if I ever make any changes in the future. The silver solder did...

I just completed this build. Sourced majority of components through Auber Instruments and BrewHardware.com. Extremely happy with both suppliers. Control panel build went smoothly, found lots of helpful schematics online for reference. I silver soldered a total of 5 1.5" TC fittings for...