Recent content by pg_rider

Yes, sold -- thanks for the interest!

Converted my kegerator from a single-keg to a dual so I bought a new regulator. As a result I'm selling my single one. It's a TapRite dual gauge that works perfectly. Not sure how old it is or what model it is as it came with the kegerator I bought. Looks like similar new ones go for...

Funny -- I just measured them and sure enough they're identical. I guess the clear inside of the red one created an optical illusion lol. They both certainly felt tight on the barbs, and I used a clamp to be sure.

I recently converted my kegerator from a single to a dual setup. The original beer line was a basic red 5/16" ID. The new line I ordered from Beverage Factory is a 5/16" ID blue one, but it's a different construction -- see below. Should I care? The red one looks like it has an inner...

Dual regulator is on the way. I'd like to sell the single -- any suggestions for where?

Would this be the sort of regulator I'd want, assuming I want to control each keg's pressure independently? http://www.beveragefactory.com/draftbeer/regulator/twoproduct/dual_primary_co2_regulator_t752hp.html

Hey guys, I have a basic fridge kegerator setup as seen below: I just finished my first keg (a 15 gallon keg of Shiner in 7 weeks -- pretty impressed! lol) and I want to convert over to a dual keg system. My question is, should I: 1) Stick with my current 20lb CO2 tank and switch...

Hi folks, first post here. I'm finishing my basement and plan to install a keg fridge in my mechanical room which conveniently shares a wall with my bar. My plan is to run a line from the fridge to a wall-mounted tap on the other side of the wall. The total distance of the exposed line should be...