Recent content by N. Homebrewer

I was confused at the moment. It is the 5/8" BSP or 7/8"-14. My apologies for the confusion being passed on. Thanks much!

I found a hydraulic fitting for 5/8 female to 1/2" male and I am going to try combining that with a 3/4" to 1/2" hex bushing. Not in stores but found it online for $4. When it comes in I will update you on either success or failure. Thanks much!

And the confusion regarding the diameter of the shank went with the 5/8" being equivalent to 7/8"-14 thread as shown in the product above

I think the best bet for me is to use this fitting and a 3/4" to 1/2" hex bushing

Absolutely! The shank that I have has an outer diameter of 5/8" non traditional but nevertheless true. I am looking to make a cheap draft tower out of steel piping and at the smallest diameter possible to allow for usuable room on top of the kegerator. I am going with 3/4" I had laying around...

Does anyone know of a fitting that could reduce from 3/4" to a female 5/8" diameter to screw a faucet shank into rather than needing a larger diameter pipe to fit the traditional facet fastening system.

Hi everybody, I am building my kegerator using a coffee bar that I have and need help to determine the material that is going to sandwhich the evaporation lines to the foam board insulation. I don't have a lot of knowledge on what material would be adequate for proper release of heat to occur...