Recent content by mnbrewr

Awesome news! Thanks for sharing

Maybe pull a few more pints off and see if it gets better? I've had some beers where some yeast and sediment obviously transferred to the keg and it took 3-4 pints for it to clear out. Though I don't usually get a sour taste (just yeasty).

I moved from a 3V Blichmann top tier setup to an eBIAB system and have no regrets. It knocked about 3-4 hours off my brew day (much of it in setup/takedown/cleaning). The big tradeoff is efficiency as others mentioned but there's steps you can take to minimize that. I've been asking myself...

/subscribed

Welcome!

Welcome!

My best suggestion is to make sure you take detailed notes throughout your brew day. What went well, what didn't, what would you change, etc. If you're using software like BeerSmith it likely has places where you can enter various measurements throughout the brew day (pre-boil volume, post...

Welcome Ken!

welcome back!

I've done several orders from Ritebrew as well since NB/Midwest closed. Good experience so far.

I keep a keg of hard selzer on tap for my gf. I take the easy way...mix vodka & water to your desired abv and add some lime or lemon juice plus a small amount of salt and sugar.

I found that in my setup the flow was most restricted at the ball lock, such that when pumping through the ball lock and out of the tap I didn't seem to get a healthy flow out of the tap. I was worried that the inside of the tap wasn't getting fully submerged in the cleaning solution so I...

I use a cheap pond pump and a small bucket to cycle cleaner through my tap lines. While its running I open and close the taps a bunch of times. I've never found any crud inside my taps with this method but I'd bet it is highly dependent on the design of the tap. This post has a short vid of...

I'm in the same boat in MN. I just picked up a few additional packs of liquid yeasts before they close for good with plans to start a frozen yeast bank but maybe I should just give this dry yeast thing a try...

Ugh, bummer, Medina is a bit of a haul for me. Probably worth the trip for a couple 50lb sacks though.