Recent content by microbusbrewery

It looks like it’s based off the same components as the valve on the riptide pump and linear valve. Assuming so, I ordered a bunch from Orings and More | Affordable and Quality Gaskets and Seals They should be -110 and -112

Assuming you're not already on it, there's a Utah Homebrew FB group. Personally, I kinda hate FB, but there are some cool brewing-related groups. Anyway, I know there was at least one member on there that was in the St. George area. Here's the link if you're interested, Utah Homebrew

Doesn’t look like there’s much down that way as far as existing clubs. In fact, I don’t see any clubs listed on the AHA’s site south of Orem. You could always start one.

For anyone that is also having a hard time finding Black Treacle locally, I ordered some from Goodwoods British Market out of Texas. I believe there was a minimum order requirement, but they shipped free and at the time I was ordering, they were much cheaper than what it was selling for on...

I went to my local Sam's Club in West Jordan, UT about a week ago. They still had a couple of Tramontinas and they had the Frigidaire right next to it. Visually they looked exactly the same. Same dimensions, same door handle, same controls. It looked like the only thing different was the...

I haven't run them that hot since building these new ferm chambers. That said, a couple years ago I brewed a Saison using Wyeast 3724 and was able to maintain temps of 92F in my old ferm chamber (full size fridge) using a Brewers Edge Space Heater. So, they should work, but I haven't confirmed...

Brew Hardware also has a bulldog. I have both the bulldog and the sanke pressure transfer kit, although I just barely bought them and haven't used them yet. I don't really have any concerns though, everything I've gotten from Brew Hardware has worked well. Re the sanke one, it includes a...

Ok, so I guess the "good news" is it probably wasn't entirely user error on my part. Did you by chance hold down the Boot button the entire time you were flashing? That's about the only thing I can think of doing differently on the unsuccessful attempt vs the successful attempt on the...

Sorry for the slow reply. Yes, I had to press the boot button momentarily. Once it starts writing files, I was able to release the button. But if I didn't press the boot button, it would eventually time out (after about 20-ish seconds).

This is the one, https://m.aliexpress.com/item/32896625954.html?trace=wwwdetail2mobilesitedetail&productId=32896625954&productSubject=ESP32-OLED-Wemos-WiFi-Module-Bluetooth-Dual-ESP-32-ESP-32S-ESP8266-OLED-For-Arduino To be honest though, it might have been me that screwed it up. I'm pretty...

I think I must have gotten a bum board... or my big meat mitts somehow managed to damage it I ended up ordering another board off of Amazon and it was up and running in a matter of minutes. The following is the replacement board I ordered through Amazon. The overall size is just a tad...

Mine came today so I've been trying to set it up tonight. Disclaimer, this is the first time playing around with one of these boards. I'm having a bit if a problem since flashing it. Quick version: Bought one of the ESP32 "OLED" boards linked to in the documentation. I opted to install using...

Ok, so I think I'm going to go the more basic route and go sans drain. Hopefully I'll have some pics to post soon showing the finished results.

My board is slowly making its way from China. Seems like it was stuck on a Chinese airplane for about seven days, which had me a little worried. I can't wait to get this set up and running.

Yeah, the only times where I ended up with a lot in the drip tray was when a couple different friends were pouring their own, and didn't know what they were doing...pouring with the faucet halfway open, then wondering why their glass was half full of foam, and continuing to pour to try to get...