Recent content by mgude

I have an electric brew system with a single pump that I have been using for almost a year now. At this point I spend a lot of time moving hoses to route hot liquids to where they need to go and cleaning up spills from draining hoses. What I would like to do is build a manifold to control the...

http://www.auberins.com/index.php?main_page=product_info&cPath=1&products_id=237 It says it has "built in SSR output". Does this mean I can use it, combined with a contactor to run a 5500w heater element, thus eliminating the 40 amp SSR and heatsink?

I am curious about this as well. I am planning a system that uses a single PID to control the HLT and BK, but it would be cool to have one (or more) if these cheap temp readouts to keep track of the MLT, wort chiller, herms output, etc. I hope someone smarter than me answers you!

Will these sensors work with the Auber PIDs? Watlow RTD Sensor, Thermistor, Thermocouple, Temp Probe | eBay Will this work in the place of the Auber PID? eBay - New & used electronics, cars, apparel, collectibles, sporting goods & more at low prices

Could this be cut in down in length so that the element would thread in all the way? You would be cutting off some of the taper and you would get 2 pieces out of it! I can get these locally for $8, so it would be much easier.

First I just have to say this forum is fantastic. I am super impressed with all the great advice and expertise here. I have learned so much in the past 2 weeks here. If anything, I am overwhelmed by too much information! I am getting ready to go all-grain and all electric brewery. I have...

How about cover plates for them? Or do you have to cut your own?