Thanks, didn't think of that 🙂
I have two 140mm noctua fans inside my chamber and even though theire not very noisy it would be nice to be able to turn them off when I don't need them 🙂
Thanks @Thorrak :)
Fermentrack is up and running again but I have this message on top: Fermentrack has upgraded to a newer copy of Django which requires an additional step to complete. Click here to trigger this step and restart Fermentrack.
Clicked on the link and waited several minutes but...
Hi
Haven't been brewing for a while so my Fermentrack hasent been used. Booted it up yesterday and it worked fine. Did an upgrade and after that I only get a 502 bad gateway error when I try to connect. Tried to run the fix environment scrip and also the other stuff that was mentioned but didnt...
I set Ki and Kd to 0 and Kp to 10. Think I ended up with adding a bit Ki. Worked a lot better so looking forward to my next batch. Coldcrashed a couple of days ago and kegged today [emoji4]
That's right, I live in Norway [emoji4]
Did some pid tuning recommended by Elco and it looks better so far. Will let it go for a couple of days an see how it performs. [emoji4]
My chamber is inside where the temperature is about 17-18C
It started out very good with beer temp at set pont +-0,05C when there was high fermentation activity.
Now that fermentation is done the temperature swings much more [emoji848]
Thanks for you're suggestions. I'll order one more fan and place somewhere higer up to circulate the air better. The small chamber sensor doesn't touch anything, it hangs freely in the air.
It seems like the heating and cooling has settled down a bit but it would be nice to find out why it...