Search results

Thanks, didn't know that 🙂 No need to run the fans when cooling and heating is off?

Thanks, didn't think of that 🙂 I have two 140mm noctua fans inside my chamber and even though theire not very noisy it would be nice to be able to turn them off when I don't need them 🙂

In the device page? That could be possible but would be nice with a button in the ui 🙂

Hi. Is it possible to turn on and off chamber fan from gui? Saw under devices that it's possible to set a pin to chamber fan.

Thanks @Thorrak :) Fermentrack is up and running again but I have this message on top: Fermentrack has upgraded to a newer copy of Django which requires an additional step to complete. Click here to trigger this step and restart Fermentrack. Clicked on the link and waited several minutes but...

Hi Haven't been brewing for a while so my Fermentrack hasent been used. Booted it up yesterday and it worked fine. Did an upgrade and after that I only get a 502 bad gateway error when I try to connect. Tried to run the fix environment scrip and also the other stuff that was mentioned but didnt...

I set Ki and Kd to 0 and Kp to 10. Think I ended up with adding a bit Ki. Worked a lot better so looking forward to my next batch. Coldcrashed a couple of days ago and kegged today [emoji4]

That's right, I live in Norway [emoji4] Did some pid tuning recommended by Elco and it looks better so far. Will let it go for a couple of days an see how it performs. [emoji4]

My chamber is inside where the temperature is about 17-18C It started out very good with beer temp at set pont +-0,05C when there was high fermentation activity. Now that fermentation is done the temperature swings much more [emoji848]

Is this better? It's from my phone, can probably get a better picture from my pc[emoji4]

Something strange is gong on here. Seems like the beer temperatur is taking off again. Anybody have an idea whats going on?

Had a fan lying around so added it to the chamber [emoji4] It's a bit noisy so will probably order one or two quieter.

Yes

Thanks for you're suggestions. I'll order one more fan and place somewhere higer up to circulate the air better. The small chamber sensor doesn't touch anything, it hangs freely in the air. It seems like the heating and cooling has settled down a bit but it would be nice to find out why it...

This is the thermowell I'm using.

No. I checked and it's above the trub.

Yes, I have a fan that circulates the air. I have used the same heater for a couple of years I think. It's a 45w tube heater so it shouldn't be to much? The beer temp is measured in a thermowell near the bottom, with the ball valve The sensor on the left in the picture is not connected to...

First time using Fermentrack but have been using Brewpi for some time. Started fermenting a NEIPA 5 days ago and it was going fine until a couple of days ago when the beertemperature went from constant 20c +- 0.05c to swinging between 18,9 and 20,5. Any idea whats wrong?

Thanks [emoji106] it worked [emoji4] Didn't know how to reset EEPROM so had to ask [emoji4]

Can't assign a temperature sensor. Only get this message: Failed to write the configuration to the controller. If this continues, try resetting the EEPROM on the controller. What to do?