Recent content by Mattymcd

I insulated the 8ft lines then had it run through a beer cooler which cooled the faucet and the beer down then to a 2ft insulated line to the faucet. The keg was at a perfect temperature 38 degrees, I filled around the gaps at the top of the fridge with expandable foam so there wasn't a...

Hey jonnyrotten just thought I would show you the perfect pint I pulled out of the worst setup you had ever seen and would never work 🖕🏻🖕🏻🖕🏻🖕🏻🖕🏻 Everyone else Thankyou for the help couldn't of done it without all...

Thanks dude appreciate the help and advice

I did not do any research I simply took all these components for free and thought I would give it a go and do some research along the way. The fridge is now at 38 degrees the lines have been changed to 3/16 with no connectors in the middle also insulated as well, the regulator is at 8-10psi...

Yep I had to cut open the top of the fridge as the fridge was too small. Was also keeping the keg too cold so I thought this would adjust the temp abit as well. I know any other way of keeping the beer line cold it's got to run under the table to the faucet surely?

Thankyou guys for the help I realise I have the wrong setup I just thought I could make minor tweaks to get it right. As I say this is all new to me, I was given this setup and told it worked perfectly as a home bar setup I guess not. I will rectify all these wrongs in the following way. I...

4

3

2

1

Guys you are reading this extract from a lost man, I am at the end of my tether I have put a couple of posts on here the past week I am getting problem after problem with pulling a pint without foam. I thought at first it was because the keg was at room temperature, I bought a fridge and put...

I don't know if it'll be a pump probably an electric motor. I bought a keg of Stella Artois and have about 5 different faucets. I could only use two of them as these had one line into them the beer line where as the other had 2 beer lines and a co2 line. My co2 goes straight into the keg...

I'm clueless with electrics guys but you's are right looks like I need an electricians help. It's getting connected to a 24v ac transformer.

Nobody know? :confused: