Recent content by junior627

Reviving this thread. Let's see those new 3D printer projects.

Following because I'm interested in this product as well.

I had bottles in fridge with keg so that they would be same temperature. Do you not use rubber stopper Dolomieu?

My cane fits snug inside the picnic tap. I will have to try different bottles to see if the stopper fits better.

So i tried again last night. After dropping temperature 5 degrees and bleeding pressure few hours prior. worked better but still had foaming. I think i narrowed it down to the stopper not fitting the bottle. it is very loose. LHBS said it was a #2 stopper but it doesnt make good seal to build...

Thanks Yewtah - I will try turning down to 2 PSI for a few days. Geoffm33 - I carbed with 18psi at 50 Degrees = 2.54 volumes CO2. The house is 4ft. yes i turned of gas before bleeding.

Attempted to bottle my Kolsch last night but all i got was half bottles of foam. 1. bled pressure from keg. 2. Turned pressure down to 2psi 3. Attached bottling wand with #2 stopper to picnic tap. 4. Stuck in first sanitized bottle.(stopper didnt fit bottle snug) 5. Fully opened picnic tap...

I was just thinking of ways to mark my new kettle. Great job, very professional looking.

I am limited in space in my NYC condo so i was thinking about building a vertical kegerator/fermenter combo. The basic design of the kegerator would be as per https://www.homebrewtalk.com/entries/custom-danby-conversion.html Instead of the tower i would have a fan connected to 3" hole to blow...

Cant wait to read it.

Confirmed it is a 10 gallon. There is a slight drip from ball valve but i am assuming that is because i didnt not install with teflon tape. Do you remove valve after every brew or can i leave in place?

10 is what i ordered. i will verify once i can fill with water

Ok so i received the kettle this morning. took out of box and was surprised to see weldless fitting instead of the welded ones i ordered. i think i like weldless better. Pot feels really sturdy. i will update once i can fill with water afterwork.

I pulled the trigger and purchased one. i will update when i receive it. fingers crossed.

Has anyone purchased a brew kettle from the Amazon Store Front - Bargain Home Brew http://amazon.com/B00HEQM7M2? Thoughts/Opinions... Thanks